How much pressure fluctuation is too much in pressure canning?
I am pressure canning for the first time and I have a horrible liquid loss / syphoning situation going on. Basically 50% of my slightly larger jars (250ml) end up with less than 50% liquid and I need to put them in the fridge. The situation is somewhat better with smaller jars.
I try to follow some basic best practices in order to avoid these problems:
- I try to remove bubbles as best as I can
- I don't raw pack, however by the time the paprika are skinned and ready for packing, they are already cold.
- I top up with hot water to mitigate the coldness.
- After finishing the canning, I stop the heat and don't open the vent, I let it cool down, before I open the canner.
My pressure canner unfortunately is designed for medical applications and it has an automatic vent, which releases when 125C is reached. However in practice the pressure fluctuates between 125C and 130C.
Is this level of pressure fluctuation bad?
Should I try to optimize for more stable pressure, or should I rather work on other factors like preheating before packing, experimenting with produce to liquid ratio when packing, getting better jars and lids or perhaps try to heat up and cool down even more gradually?
I tried manually operating the on / off button and keeping the temp between 122C and 124C (with some exceptions, every now and then I would need to leave for a minute and the pressure would rise to 130C and than fall down back to 125C with the help of the automatic release), but the result was the same: lots of liquid loss.
Pictures about "How much pressure fluctuation is too much in pressure canning?"
What happens if you use too much pressure when canning?
If the pressure gets too high, the weight jiggles and releases steam and pressure. No blowing up. You do need to monitor your pressure canner while it is building pressure and during processing.How often should a pressure canner jiggle?
Conclusion \u2013 How to Use a Jiggle Top Pressure Cooker Using a jiggle top pressure cooker resembles most of the other pressure cookers, except it jiggles when it reaches full pressure. This tells you to turn down the heat. The pressure cooker should jiggle an estimated one to four times per minute.How high should water be on jars in a pressure canner?
Put 2 to 3 inches of hot water in the canner. Some specific products in this Guide require that you start with even more water in the canner. Always follow the directions with USDA processes for specific foods if they require more water added to the canner. Place filled jars on the rack, using a jar lifter.What happens if I use 15 lbs pressure instead of 10 when canning tomatoes?
Part of the problem is when 15 lb. pressure is used and zero or one minute processing, there is not sufficient time for all of the air to vent out of the canner and for the internal canner temperature to raise. Using 15 lb. pressure at zero or one minute processing will increase spoilage.\u201dYOUR Pressure Canning Questions - ANSWERED!
Sources: Stack Exchange - This article follows the attribution requirements of Stack Exchange and is licensed under CC BY-SA 3.0.
Images: Nathan Cowley, Andrea Piacquadio, Andrea Piacquadio, Pedro Figueras