Roasted Pork Leg is Dried Out

Roasted Pork Leg is Dried Out - Fried Dish on Plate

Every time I try to roast a pork leg a lot of water drains from it and it becomes dry.

Last time I did it this way: 24 hours before, I seasoned a 1.5kg (3 pounds) piece with salt, pepper, garlic, orange juice and lime juice. I put it out of the refrigerator 1 hour before roasting, and roasted it (covered), with low heat (150° C, about 300° F) for about 2 hours in the seasoned juices. When roasted, I let the meat rest for 1 hour. Still, the leg was kinda dry.

What could be wrong? The oven, the meat? Something in my process?



Best Answer

It is hard to tell just from text descriptions, but I believe your pork leg is under-cooked.

Note that it is likely fully cooked in the sense of safety, but it has not had long enough for the slow process of collagen to gelatin conversion.

Pork legs (or hams, depending on what you have exactly) are well used muscles with a lot of connective tissue, comprised of the protein collagin. This is tough, even when fully cooked to 165 F / 74 C (which is well done for most meats).

At temperatures above above 180 F / 82 C, in the presence of water (which is in the meat already), the collagen will begin to convert to gelatin, which has a moist, unctuous texture.

This process is both time and temperature dependent. At lower temperatures, it takes more time; at higher, it is faster.

Continuing to slowly roast your pork leg will allow this slow conversion to happen, making it again become tender and unctuous, because of the lubricating affect of the gelatin. In fact, it will eventually be pullable just with a couple of forks (although shoulder is even better for this).

You would probably be better served by cooking it at least three hours; four might be even better.

See also:




Pictures about "Roasted Pork Leg is Dried Out"

Roasted Pork Leg is Dried Out - Roasted Porchetta in Close-Up Photography
Roasted Pork Leg is Dried Out - From above of tasty grilled pork steak with barbecue sauce served with salad and fried potato on table near mug of beer
Roasted Pork Leg is Dried Out - Fly on ground with stones



Quick Answer about "Roasted Pork Leg is Dried Out"

“Unlike other pork, it doesn't have much connective tissue or covering fat, which is why it often ends up dry.” In other words, this stuff is infuriatingly easy to overcook.

How do you fix a dry pork roast?

Simply soak the pork loin in a saltwater bath for at least 2 hours. Or use your favorite marinade recipe. The marinade should have an acidic liquid like apple cider vinegar. This will help you avoid getting tough and dry pork.

How do you add moisture to a dry pork roast?

In a word, yes. If pork shoulder or pork butt is allowed to cook past 210 degrees or so, the meat will begin to dry out. This will affect the quality of your pulled pork, even if you smother the meat in barbecue sauce before serving it.

Can you overcook pork leg?

This is tough, even when fully cooked to 165 F / 74 C (which is well done for most meats). At temperatures above above 180 F / 82 C, in the presence of water (which is in the meat already), the collagen will begin to convert to gelatin, which has a moist, unctuous texture.



Street food - The Master Has The Skill Of Cutting Giant Roast Pork




More answers regarding roasted Pork Leg is Dried Out

Answer 2

Roast pork, bone in or boneless, needs low oven temperature and lots of time. The answer to your question is you were too hasty. After your prep, use an oven temperature of no more than 300 degrees F for about 50 t0 60 minutes per lb., when the internal temperature reaches 165-170 degrees. Slow and steady is the way to roast pork, and it's good to invest in a good probe thermometer such as an instant-reading Themapen.

Answer 3

These guys who have a little experience roasting pork have this to say:

The hams, the large rump muscles on the rear legs are the thickest and most dense muscle group. They are best when smoked to about 175°F.

[...]

Cook low and slow. Normally I tell readers to cook most foods at 225°F and to learn how to peg their cookers at that temp, but if you don't crank the temp up a bit a hog can take forever. So we'll take it up to 250°F or so.

The higher temperature is for a whole hog; a single cut would probably work at the lower temperature.

Sources: Stack Exchange - This article follows the attribution requirements of Stack Exchange and is licensed under CC BY-SA 3.0.

Images: Harry Dona, Cleo Vergara, Nishant Patel, Egor Kamelev