Solder for steamed pudding mold
My small steamed pudding mold has sprung a leak. What type of solder should be use to repair the leak? Thanks,
Best Answer
If it's copper or brass you should be able to use solder used for drinking water plumbing (tin with a little copper, and no flux in it). This will probably work on tin or tin plate as well.
You'll probably need to use separate flux as well. Again get something used for potable water. Give it a very good wash and rinse afterwards.
For more advice you can probably look at what people do for brewing. This has actually been discussed on diy stack exchange before.
Pictures about "Solder for steamed pudding mold"
What Makes This Spotted Dick So Good? A Classic British Steamed Pudding With Vanilla Custard
Sources: Stack Exchange - This article follows the attribution requirements of Stack Exchange and is licensed under CC BY-SA 3.0.
Images: Ella Olsson, cottonbro, Pixabay, Anna Shvets