Overpressurizing a cream whipper?
This might be considered off-topic, but thought it was worth asking, as I have no idea where else to ask --
I'm trying to make something forcibly eject from a cake. I've done some testing with a can of reddi whip, and I've found that I can get decent distance by restricting the size of the opening. But I'm debating on getting my own whipper, thinking that I can then tint the results, but that I might also be able to charge it more than once to get a more forceful ejection.
Are there any problems with over-charging a canister? In the response to the question about ragged peaks from a whipped cream dispenser, one of the responses said it might be from over-charging the container, so I'm a little concerned. (not that much, as it just needs to shoot out, being pretty isn't necessary, so ragged peaks aren't an issue; the whole thing turning to butter and clogging the canister or being inedible would be)
(I also assume there's a safety margin so it's not an explosion issue if I only double or triple charge it... I seem to remember my mom once double-charging one, when it didn't dispense, only to find out she had clogged it up with home-grated nutmeg; there wasn't an explosion 'til she tried taking the lid off)
Best Answer
Charging a whipper two or three times is definitely not going to make it explode; for certain lower-density preparations you're supposed to charge it twice, but even if that weren't the case, consider that one of the chargers holds only a fraction of the volume of the whipper itself (8 g, to be exact), so if the chargers don't undergo explosive decompression then it's definitely not going to happen to the whipper.
As for it possibly turning into butter, that's a more realistic possibly depending on what you're putting inside it. I can't verify whether or not it happens with cream since I've never tried it and probably never will; I wouldn't recommend it, since whipped cream gets very dense to begin with.
But honestly I think your biggest problem is going to be that whipped cream dispensers aren't designed to dispense upward. The instructions are very explicit that you have to hold it upside down in order to dispense; if you hold it right side up then it's just going to vent the gas and make it impossible to get the cream out with opening it up.
Simply stated, the cream is much heavier than the gas, and I believe that whippers don't actually achieve saturated vapour pressure inside. That's why the gas will always eventually end up on top no matter how you orient the whipper; the key to getting the cream out is forcing the gas back down through the cream by depressurizing it, which is why you need to hold it upside down.
So unless you want to eject it from the bottom of the cake, I'm sorry to say that I don't think this is going to work for you.
One alternative you might be able to try is to pre-whip the cream with a stabilizer or make a fondant, then put it into a hollow tube and eject the gas from the whipper into that tube. That way you can guarantee that the "liquid" is actually in the path of the gas, and the gas should propel it upward. I emphasize should; it's going to depend on the density of what you're trying to propel and how good your seal is, and you'll probably have to experiment a little.
Pictures about "Overpressurizing a cream whipper?"
How do you depressurize a whipped cream dispenser?
Point cream whipper into sink or trash and squeeze trigger until pressure is released. Lid may now be removed. Do you find this helpful? Just hold the handle with the nozzle pointed up, and all of the gas comes out.Can you overfill a whipped cream dispenser?
Check to be sure that the white head gasket is in place inside the head. Screw the dispensing tip onto the head. Screw the head onto the bottle securely TIP: The cream mixture should be cold when poured into the whipper bottle. TIP: Do not overfill \u2013 the remaining head room is needed to optimize whipping results.How do you unclog a whipped cream?
Warm water should help loosen the butterfat. Another issue is a congested nozzle from leftover butterfat and sugar inside of the nozzle. To fix this, just turn the can upside down with the lid on in a cup of warm water for a few minutes.How To Use A Whipped Cream Dispenser
Sources: Stack Exchange - This article follows the attribution requirements of Stack Exchange and is licensed under CC BY-SA 3.0.
Images: Polina Tankilevitch, ROMAN ODINTSOV, Ivan Samkov, Polina Kovaleva