How can I clean dark non-stick pots (e.g. Calphalon)?
We have Calphalon non-stick cookware and it seems, after 5 years, not to want to get clean. Even the best scrubbing leaves kind of a hazy look on them. Additionally, the exterior of our most used pan is darkly stained, kind of like a well-seasoned cast iron pan. Is that okay, or do I need to clean it better too?
Best Answer
I'm gonna assume you're talking about pans with a hard anodized exterior and non-stick interior...
The anodized exterior will pick up stains over time, and you probably shouldn't worry too much about trying to get them back to factory condition. That said, you can find some tips on How should I clean anodised cookware? - I use baking soda and elbow grease for routine jobs, and occasionally resort to Ajax (scouring powder) for touch-up around the handle.
The non-stick interior is probably just wearing out. AFAIK, some Calphalon non-stick pans have a texture to them that is supposed to improve browning, but over time even smooth non-stick surfaces develop pits and scratches that create opportunity for residue to hold on to. I use a bit of baking soda and a bit of salt to scrub these clean, but once something gets stuck on to the point where serious scouring is necessary to remove it you'll just have to give up (since that would take the non-stick coating with it). Non-stick pans - even well-made ones - do tend wear out faster than ordinary pans, and there's no getting around that.
Pictures about "How can I clean dark non-stick pots (e.g. Calphalon)?"
How do you make Calphalon pans look new?
To do so, simply mix 1 cup water, 2 tablespoons baking soda, and \xbd cup white vinegar in the pot or pan that's lost its stick, set on the stove, and heat until boiling for 10 minutes. Wash the pot as usual, then rub vegetable oil on the surface to re-season it and get the non-stick surface back.How do you get brown stains out of Calphalon pans?
White vinegar is an excellent solution for salvaging burnt non-stick pans. Once the pan has cooled, pour in a generous glug of white vinegar, along with enough warm water to cover the burnt areas. Stir in two tablespoons of baking soda, heat the mixture up, and bring it to a boil for a couple of minutes.More answers regarding how can I clean dark non-stick pots (e.g. Calphalon)?
Answer 2
In my opinion, water spots, lecithin, sometimes burnt oils, and micro scratches can affect the non-stick surface reducing its non-stick ability.
I have found that a bit of elbow grease with some brown heavy paper (like a piece of a paper bag) can do wonders to regain much of the non-stick properties. I normally do this with a bit of water and a few pieces of paper bag. In a swirling and rubbing manner, reversing directions a few times, scrub the surface with a couple of fingers and good pressure. With time you will notice that the water will start beading again! The color may be restored or not, but if the water beads again it will also be non-stick.
I used to use 1200+ grit sand paper with light pressure, but that only works for a while until it actaully wears away the ptfe. The paper of the bag has very fine clay in it that is abrasive enough to remove the food particles, lime, lecithin, etc. but is quite gentle to the ptfe. After cleaning I usually let it cool and use another piece of the paper with a bit of veg oil or clarified butter to scrub in some oil into any remaining scratches.
Hope someone else finds this useful. I've saved more than a couple of old pans from the trash.
Answer 3
Clean your pans before they cool.
Sources: Stack Exchange - This article follows the attribution requirements of Stack Exchange and is licensed under CC BY-SA 3.0.
Images: Flora Westbrook, Ihsan Adityawarman, Cesar Perez, Pixabay