When getting coconut milk out of a coconut what type of drill bit should I use?
I'm aware there's wood, masonry, and metal drill bits, but what type works best for getting milk out of a coconut to put lime in it?
Best Answer
I use a screwdriver and a small hammer to punch the eyes of the coconut in and then pour through a sieve into a receptacle.
It's important to have more than one opening to facilitate the juice coming out, otherwise an air-lock will quickly form.
Wearing a gorilla suit is recommended, but entirely optional.
Pictures about "When getting coconut milk out of a coconut what type of drill bit should I use?"
How do you remove coconut milk from coconut?
Place half the coconut meat in a blender with half of the coconut juice and 1 cup of hot water (Vary the amount of water to produce thicker or thinner milk). Use high speed to process for 3-5 minutes until the coconut meat turns really fine. Repeat this procedure with the other half of the meat and juice.Can I use a drill on a coconut?
DRILL, BABY, DRILL! On the coconut, at the top, are 3 marks that make the fruit resemble a bowling ball. The one that's slightly offset from the other two tends to be the softest, so this is the one you're going to drill into. If you're using a drill, dig in (and if you have one, it's definitely the easier option).What can I use to strain coconut milk?
Straining the coconut milkPlace a fine-mesh sieve over a large bowl or another container, and then line the sieve with cheesecloth. Pour the coconut slurry into the lined sieve, and then press it firmly to extract as much liquid as possible, discarding the solids or reserving them for another use.How do you drill through a coconut?
Some spots on the coconut are easier to drill through than others, so make it easy for yourself by following these instructions:How To Make Fresh Coconut Milk | Home Made Coconut Milk | World Coconut Day Special - Ruchi
More answers regarding when getting coconut milk out of a coconut what type of drill bit should I use?
Answer 2
Coconuts are pretty soft as drillable things go. Wood or metal bits would be fine. A masonry bit might not work properly, as it's designed to be used with a different kind of drill.
Sources: Stack Exchange - This article follows the attribution requirements of Stack Exchange and is licensed under CC BY-SA 3.0.
Images: Polina Kovaleva, Polina Kovaleva, Polina Kovaleva, Ena Marinkovic