Problem with "No Bake Cookies"
We have made the standard type of these for years, using a recipe similar to this one 3-Minute No-Bake Cookies.
A problem we have sometimes is that the sugar will not set (I think). The cookie should be slightly crumbly and have a granular(?) texture.
However sometimes the cookies will not set properly. The cookies remain gooey and will not harden even after a day or two.
As far as I can tell, the same recipe is followed each time. Possible variables might be boiling temperature (by eyeball, not using a thermometer), the timing of removing the heat and adding the oats, or the humidity (we are in a high (70%) RH area, so some ingredients might be affected).
Also we use Nestle Nesquik instead of cocoa. Also margarine instead of butter.
I would appreciate any insight as to why this may be happening.
ADDITIONAL INFO.
There is one additional difference from the recipe. We mix the boiled mixture with the oats in a separate bowl, rather than adding the oats to the boiled mixture in that pot. Possibly the cooling time is an issue.
UPDATE
After further experimentation, the best result was obtained by using a Dark Chocolate cocoa powder (which I presume has a higher cacao content, although the products I used did not state any percentage). Even the result of other milk chocolate cocoa powders was not as good.
Best Answer
I have had thsee problems too. Here is what I found. Margarine has changed over the years. Do not use it for no bakes, use butter. Cocoa is prefer for no bakes. As far as the gritty, or crystallized taste, do not scrape sides of pan when stirring and cooking. Crystals on the edge of the pan start a crystallization in the whole batch when stired inot the pot. It's an old fudge making tip, and no bakes are similar to fudge.
Pictures about "Problem with "No Bake Cookies""
The Biggest Mistakes Everyone Makes With No-Bake Cookies
More answers regarding problem with "No Bake Cookies"
Answer 2
This is what I found to work every time. I always use real butter, not margarine, and real cocoa, and I only add just enough milk to make a thick "mud". Just follow your regular recipe as usual , but only put enough milk in to be able to stir your mixture. Bring to a slow boil, stirring constantly to ensure your sugar melts evenly so it won’t be grainy. Bring to a full rolling boil for one minute and you should have perfect no-bake every time.
Answer 3
Margarine should be fine - as noted by James, it's called for in the recipe (and the recipe says margarine or butter, not vice versa.)
The huge difference between the recipe and what you are doing (as pointed out by Jolene) is using Nesquick (which is mostly sugar and a little cocoa and a long string of other ingredients) for baking cocoa.
The recipe difference from the "standard recipe" I grew up on is no peanut butter.
Boiling temperature is not critical - "boiling for 3 minutes" is called for, not a particular temperature. Essentially, make sure everything is dissolved/liquified, rather than any "candy-making" transformations.
Answer 4
I notice that some peanut butter or butter have slightly higher fat contents, which in return affects the consistency of the cookies: I found a layer of oil seeping through my wax paper after having used a cheaper peanut butter. And those cookies were soft and "less set". I also appreciate Beez' comment above about scraping the side of the pan, which I would take note next time.
Sources: Stack Exchange - This article follows the attribution requirements of Stack Exchange and is licensed under CC BY-SA 3.0.
Images: Brett Sayles, RODNAE Productions, Lina Kivaka, Katerina Holmes