KitchenAid beater stuck on new machine [duplicate]

KitchenAid beater stuck on new machine [duplicate] - Chrome and Black Engine Display

I’ve used my machine twice. I went to try to put a different attachment on it and the pin won’t move.

kitchen


Best Answer

KitchenAid recommends that you compress a warm, wet towel around the top of the attachment for 10 minutes. Reheat the towel and repeat for another couple of minutes. The warmth will cause the aluminum to expand, and with some wiggling, should allow you to release the attachment.



Pictures about "KitchenAid beater stuck on new machine [duplicate]"

KitchenAid beater stuck on new machine [duplicate] - White Leather Car Bucket Seat
KitchenAid beater stuck on new machine [duplicate] - A Clean Automotive Engine
KitchenAid beater stuck on new machine [duplicate] - Back view of unrecognizable workman in apron mounting window near drilling machine and doors in flat


Quick Answer about "KitchenAid beater stuck on new machine [duplicate]"

KitchenAid recommends that you compress a warm, wet towel around the top of the attachment for 10 minutes. Reheat the towel and repeat for another couple of minutes. The warmth will cause the aluminum to expand, and with some wiggling, should allow you to release the attachment.

How do you remove a stuck beater from a KitchenAid mixer?

Use a Warm Compress
  • Compress a wet, warm towel around the beater shaft for 10 minutes.
  • Re-warm it after the 10 minutes, put it on again, and let it sit for 1 -2 more minutes. This will re-warm the aluminum, causing it to expand. After this time, try to wiggle and remove the beater.


    • How do you release a KitchenAid attachment?

    If the mixer is overloaded, the Overload Reset Button will pop out and the mixer will shut off. Turn the Speed Control Lever to OFF. Wait a few minutes, then push in the Overload Reset Button. Turn the Speed Control Lever to the desired speed and continue mixing.


    Removing A Stuck KitchenAid Attachment



    Sources: Stack Exchange - This article follows the attribution requirements of Stack Exchange and is licensed under CC BY-SA 3.0.

    Images: Mike B, Mike B, Tim Mossholder, Ksenia Chernaya

    Related Questions